gt4f90io installation guide

steps

1. Make an empty directory, and extract archive.

   
           $ tar xvzf gt4f90io-current.tgz
          

   A directory `gt4f90io' created at the current working directory.

2. Move `gt4f90io' directroy, and excute `./configure'

   If your path of netCDF library is `/usr/local/netcdf/lib/libnetcdf.a', you should set options as follow.

          
          $ ./configure --with-netcdf=/usr/local/netcdf/lib/libnetcdf.a
          

   A configure file `Config.mk' created at the current working directory.

3. Edit `Config.mk'

   Then go to the gt4f90io directory and edit Config.mk.

   
           FC          : Fortran 90 compiler.
   
           SYSFLAGS    : Flags needed for Compile and Link.
                         (Options for Compile).
   
           SYSLDFLAGS  : Flags needed for Link.
   
           SYSLDLIBS   : Library needed for Link.
   
           F90MODTYPE  : Way to pass over modules informations.
   
           DEST_LIB    : gt4f90io library (libgt4f90io.a) will be installed there.
   
           DEST_INC    : gt4f90io modules (*.mod) will be installed there.
   
           DEST_BIN    : gt4f90io tools (gt*) will be installed there.
   
           DEST_DOC    : gt4f90io documents (*.htm) will be installed there.
   
   
   
           MODS        : suffix of the module file
   
           AR          : Archive command
   
          

4. Compile and Install.

   
           $ make
   
           # make install
          

   If you want to install documents in your system, execute as follow.

   
           # make install-doc